
Assessment and Mitigation of Damage Caused by an Electron Beam in Battery Materials: Toward Improved In Situ STEM-EELS Characterization Using Alternative Scanning Approaches
Abstract:
The performance of lithium-ion batteries is limited by nanoscale degradation at the electrode-electrolyte interfaces. STEM-EELS microscopy under conditions operando would allow for the study of these phenomena, but the damage caused by the electron beam limits the achievable spatial and temporal resolutions. This thesis evaluates interlaced scanning as a strategy for reducing this damage in beam-sensitive battery materials. New patterns, based on raster, rotating serpentine, and rotating Hilbert trajectories, were designed to distribute the fluence more uniformly than a conventional raster scan. The study focuses on thin films of LiF, representative of an inorganic component of the solid-electrolyte interface (SEI) layer, as well as the carbonate solvent DEC and the LiPF6 in an EC:DEC mixture. In LiF, interlaced scanning reduces radiation-induced defect formation, agglomeration, and material loss by up to 22%. Its effectiveness depends on the spacing between probe positions, the beam current, and the substrate’s conductivity. These results highlight the potential of this approach to improve the resolution of STEM-EELS studies. operando battery interfaces while minimizing beam-induced artifacts.
Keywords: Electron beam damage, Scanning transmission electron microscopy, Lithium fluoride, Non-aqueous carbonate solvents, Solid electrolyte interface, Scan patterns
Evaluating and Mitigating Beam Damage in Battery Materials: Advancing In Situ STEM-EELS Through Alternative Scanning Approaches
Abstract:
Lithium-ion battery performance is limited by nanoscale degradation at the electrode-electrolyte interface. Operando STEMEELS could shed light on these dynamics, but electron beam damage severely limits the achievable spatial and temporal resolution. This thesis evaluates interleaved scan patterns as a strategy to mitigate damage in beam-sensitive battery materials. Novel interleaved scans based on raster, rotated snake, and rotated Hilbert patterns were designed to distribute fluence more uniformly than conventional raster scanning. Model battery material samples—
—were investigated: LiF thin films as a representative inorganic SEI component, and the carbonate solvent DEC and electrolyteLiPF₆ in EC:DEC as liquid systems. In LiF, interleaved scans reduced radiation-induced defect formation, agglomeration, and mass loss by up to 22%, with the extent of mitigation depending on probe spacing, flux, and substrate conductivity. These results highlight the potential of interleaved scanning to enable higher-resolution operando STEM-EELS investigations of battery interfaces with reduced beam-induced artifacts.
Keywords: Electron Beam Damage, Scanning Transmission Electron Microscopy, Lithium Fluoride, Non-Aqueous Carbonate Solvents, Solid Electrolyte Interphase, Scan Pattern



